扬州瑞浦DCL-10B无源触点电动执行器

coupingstrictly, otherwiseprobably beyond the scope of job which the executive body designs, lead to the fact that makes the valve unable to work normall because the joumey of executive body is unable to adjust.

1．电气限位的调整 Adjustment of the limited location of electric
松开行程挡块的螺钉，用螺丝刀轻敲行程挡块，即可调整行程行行程开关挡块的角度，从而改变电气限位的开闭角度。最后，切实紧固好行程挡块的螺钉。5、10的行程挡块和行程开关布局图。
Unalamp the screw that the joumey blocked one, rap the journey and block one with the screwdriver, i.e. the adjustable journey blocks the angle of one, thus change the holding and closing the angle of the location of electric limit. Finally, fasten the screw that the good journey blocked one conscientiously. 2040／50／60／100200的行程挡块和行程开关布局图 20/40/50 60/100/200 of the travel block lumps and travel switch overall arrangement picture
2．电器位的调整（开度型、智能型 Adjustment(tum on one degree of types, inte)of the potentiometer
a．电位器的电阻值为1K2、5K2。
The resistance valve of the potentionmeter is 1kn, 5KO
b．用手柄转动动阀门到全闭位置。
Rotate the valve and reach to close the position completely with the handle
C．松开电位器，转动动电位器齿轮，用**表测量4－5接线端子间的电阻值，使4－5的电阻值到